Slurry Pipe System V1.0.1.9

FS 25 Mods |
Slurry Pipe System V1.0.1.9


This is a physical slurry pipe system for Farming Simulator 2025 that changes the usual vanilla “drive into a trigger and fill” setup. You connect tanker fill arms or build pipe chains by hand, start the PTO-driven pump, build pressure, and choose which way the flow goes. Then you can watch the slurry travel through the real plumbing. It also gets thicker, forms a crust, and can block up when it is left alone, so there is more to do than simply filling up.

Features

  • Plumbing & transfer: Swing the tanker fill arms out with the joystick and guide them into open slurry pits or the rubber boot ports on buildings and other vehicles.
  • Pipe chains: Lay down the multi-segment pipes by walking from one coupler toward the next. When both ends overlap valid couplings, they lock together.
  • Direct bez pipes: Need a quick pump transfer between a tanker and a building? Use one connecting pipe between two nearby couplers.
  • Conduit pump (PTO Slurry Pump): This passive pump trailer sits between two pipe chains and lets the transfer run through it.
  • Animated couplers and valves: The clamp handles close as you connect them, and the valve wheels turn when the valves are opened.
  • Coloured pipes: Choose a colour for every pipe segment from the palette. The colours are saved with each save.
  • Multi-fill-type support: The system works with LIQUIDMANURE and DIGESTATE. During a transfer, it automatically picks the fill type that is actually there.
  • Pump types: You can use vacuum, the stored ±bar pressure model with its gauge, the HVP high-volume pump, a conduit pump station, and openTop passive vessels, including nurse tanks.
  • Pressure model: Vacuum tankers build and hold a stored charge, then taper and purge it. That charge drives filling and discharge, while spreading changes with pressure instead of just being on or off.
  • PTO shear bolt (opt-in): With the PTO engaged, the bolt turns under load, wears down, and snaps if pushed too far. Walk up and hold the repair action to fix it.
  • Thickness / dry matter: As dry matter concentrates, the slurry becomes thicker. That thickness changes how it flows and spreads.
  • Crust & blockages: Leave an unmixed store through the season and it crusts over. The crusted, lumpy slurry can block spreader outlets and the macerator. Mixing clears the risk, and water makes thick slurry thinner.
  • Agitation: A manager-driven agitator works on every registered vehicle with an agitator tip node. No specialization is needed.
  • Water intake: If the map provides SPS water planes, the fill arms can pull water directly from its lakes and ponds.
  • Dribble bars & band spreaders: There is blockage modelling for every outlet, plus a distributor macerator and a spreader HUD.
  • Fertiliser / herbicide sprayers: Liquid fertiliser or herbicide goes through the same coupler-and-pipe system using dedicated sprayer integration. You operate it from one walk-up pump control. Sprayers use a flat rate and do not have the pressure model.

Changelog

  • V1.0.1.9
    Multiplayer fixes were made to the physical hose system after server players reported and retested them. The invisible hoses from the original hose system are repaired. Fertilizer/pesticides can be sent through the water hose now, and the Borger 125 Separator has also been revised. You do not need configuration changes, and existing save games work unchanged.

    New fertilizer/plant protection product via water hose (physical hose system): The 80 mm water hose connects to field sprayers, fertilizer/plant protection product silos, IBC containers, and purchasing stations. On the matching sprayer, press “B” to start or stop the flow and “Y” to switch between “loading” and “unloading”. Press button “X” first to open the cover. The milk hose stays for milk exclusively.

    Borger 125 Separator: You now get an information box with separated slurry details, in kg/t, source, return flow, status, inflow rate, and solids content. Its control panel shows the values in real time, solids visibly come out of the discharge chute, and use brings soiling, wear, and moss growth. The switch shows a wrench symbol. Fresh slurry pumped into the storage tank dissolves any crust that forms. The tower mixer can now be purchased in the shop.

    “Clean” Log: Messages about hose connections only show up with “spsDebug Info” enabled.

    Fixed Bugs Multiplayer (Dedicated Server): Picking up items manually with teammates either failed or caused the item to drop straight away. Hoses were only grabbable at the female connector, and “female/female” or “male/male” connections could not be picked up. Dropped hoses floated in mid-air for teammates. A hose that was connected or stowed before someone joined appeared loose for that player.

    Physical Hose System: Tank trucks, such as Kotte TSA, could rotate without control when a hose was attached to the rear connector. Connected hose ends did not offer a disconnect prompt. Reloading a save detached connected hoses and left a “stretched” hose visible at the connector. A laid-out hose could vanish after a small camera movement. One machine can no longer have a hose connected to both of its ports.

    Original hose system: In version 1.0.1.8, an automatic hose connection between two ports worked but could not be seen. It is now displayed graphically. For sprayer, water, or milk hoses stored at more than 4 meters, the connection prompt appears only when you are close enough. Park closer to keep the hose connected.

    Separator “Source empty” when the storage is full: fixed.

    Note: On dedicated servers, the piping mode prompt is not shown at startup. An administrator can configure the physical piping in the PLC settings instead.

  • V1.0.1.8
    Description: Physical hoses, PLC docking station, PLC tower mixer, and numerous troubleshooting tasks are included in this version.

    Newly added Physical hoses: You can buy and carry hoses, connect them, and manually connect them to each other instead of using only permanently installed lines. Every hose type has its own shop page: slurry/water/milk, 4 m or 6 m lengths, various connectors, and colours.

    To release stuck hoses, left Alt key + F while holding a hose: Move the hose through vehicles until it releases. Hose holders are fitted to tank trucks and the SPS docking station, which works as a mobile connection point.

    SPS tower mixer: This is a slurry lagoon agitator with an integrated pump for filling tank trucks.

  • Flow indicators for pumps, PTO pump and tower mixer, show why a pump has stopped as well as the flow. The flow rate also appears in the tank truck HUD.

    Water and milk can move through hoses, with valve connections, gravity flow, and transfer between tank trucks. The central cow barn (SPS) and fertilizer/herbicide silos are supported too.

    Hoses, docking station, PTO pump, and tower mixer get dirty and wear out. Clean them with a pressure washer. The build menu can draw custom waterways.

    Bug fixes Multiplayer: Valves, pumps, and connections now synchronize. Players who join receive the right status, only an administrator can change PLC settings, and other farms cannot use your equipment. Shear bolt status is saved. The floating layer in slurry lagoons synchronizes per lagoon. Gea/Vector cow barns use their own configuration. The Farmtech SuperCis 800 now has a hose holder.

    Shop: The shop includes the “Slurry Technology” category, “PLC Slurry Set,” cameras, and hose previews.

    Changes: Routine messages were moved to the “Info” debug channel for a more organized log. The download is approximately 50 MB smaller, and the processing load per frame is lower.

  • V1.0.1.7
    Alle wijzigingen sinds V1.0.1.6. Geen wijzigingen aan het configuratieschema; opgeslagen spellen blijven onaangetast. Opgelost: De achterste klep opent niet langer bij tankwagens met <turnedAnimation> wanneer de pomp wordt ingeschakeld. Probleem met Abbey-tankwagens: met de PLC geïnstalleerd opende de achterste klep wanneer de pomp startte. Oorzaak: het XML-bestand van de tankwagen bev

Author: Willbobber

Download


Farming Simulator 25 mods open the door to endless ways to customize and elevate your game. With free tools and tweaks that make every hour more immersive, you can shape your game exactly how you like. Try the FS25 Slurry Pipe System V1.0.1.9 mod to give your game a fresh touch of atmosphere, and explore countless other options to keep upgrading your experience, all without limits.
Useful Information: How to install FS25 Mods | FS25 Guides | Complete Modding Guide | Download FS25 Game

Leave a Reply

Your email address will not be published. Required fields are marked *