You get 7 rotary lobe pumps, connectable hoses and a full fluid transfer setup for Farming Simulator 25 in this pack. Water from lakes, rivers, tanks or MapFlood floodwater can be collected, moved and pumped into vehicles, containers or other bodies of water. That gives you a lot to connect, place and build with while managing your water and liquid transfers.
Features
- Rear three-point hitch
- Front three-point hitch
- Forklift skid
- Crane lifting frame
- Roll-off container pump station
- The drive depends on the model, with either the PTO or a diesel engine providing the power.
- Pick up hoses one at a time, carry them, lay them out, extend them and connect them together.
- Hoses come with their own physics, smooth bends and sturdy couplings.
- Connect multiple pumps in series by taking the pressure outlet from one pump to the suction side of the next.
- Run all pumps at once and their flow rates are added together. This lets you put together longer transfer lines too.
- Interactive Control
- Attach Implements Manually
- Realistic Exhaust Smoke
- Original GIANTS diesel sounds
- Freely selectable pump and hose colors
- Dedicated shop category: Water Pumps & Hoses
Controls
- Left Alt + 1/2: Start/stop engine
- Left Alt + 3/4: Turn pump on/off
- Left Alt + 5/6: Change RPM
- Left Alt + 7: Refuel diesel
- Left Alt + N: EMERGENCY STOP
- Left Alt + 8: Connect/extend hose
- Left Alt + 9: Connect/disconnect coupling
- Left Alt + 0: Stow hose
- Left Alt + V: Stow all hoses
Specifications
- A 400-litre diesel tank is included in the roll-off container.
- PTO pumps work between 350 and 1,000 RPM.
- Maximum suction height: 8.5 m.
- Use the displays to see RPM, flow rate, pressure, vacuum and fuel level.
Hose System
Blue = suction side
Red = pressure side
Pumping Fluids
Supported sources:
- Lakes and rivers
- MapFlood floodwater
- Tanks and trailers
- Water, milk, slurry, digestate, liquid fertilizer, herbicide, diesel, AdBlue, oils and other liquids
Fill vehicles, tanks and unloading points from the pressure side. Liquid can also come straight from a free hose end.
MapFlood floodwater is correctly taken into account when it is pumped out.
Changelog
- V1.4.2.1
New water jet: each frame follows the real ballistic trajectory until the jet reaches the ground or water surface. The trajectory uses exit velocity based on flow rate and hose cross-section, the direction of the hose end and gravity. The result is one continuous stream with no discontinuities in hose thickness, using the game’s waterfall material. The game’s impact spray is scaled to match the flow rate, and the distorted rice-field water surface has been removed. Measurements have been made for fittings and signs on the finished model: pressure gauges sit on the uppermost surface beneath the dial, color rings go around the actual pipe circumference, and signs are used only on straight pipe sections, either long, two-line or short depending on the space available. Nothing is embedded in the model anymore. Interactive-Control buttons now appear 1 m farther away and remain visible.
