





The Cotton Line lets you run a full southern-built cotton harvest setup, starting with the first pass through the rows and ending with a module headed to the gin. Every machine was built from scratch for this pack. You get full animations, working hydraulics, safety decals and vmask wear, plus equipment made to work together. It is a complete line to drive, load and build with.
Features
- Drive the John Deere 9970 cotton picker with its classic 4-row basket picker, hydrostatic drive, front duals and rear-wheel steer.
- The heads split into two 2-row sections, and each half lifts separately. Press
Left Shift + Zto cycle left up, right up or both down for point rows and short ends. Lift a head and picking stops. - On the road, fold the high-dump basket down. When it is time to unload, tip it into a boll buggy or module builder.
- The spindle water tank sits behind the cab and drains as you pick. Fill it at any water point and the head will not run dry.
- Step out and the folding cab ladder drops. When you or a hired helper runs the picker, it flips up beside the handrail.
- Look around the detailed cab with its working dash, light bar, CB whips and flag. The PTOs and drums on all four row units spin too.
- Pick the Factory design, as built, or the cheaper Used design with sun-faded paint, chalky snouts, worn decals, rusty tips and a few replaced snouts.
- Advanced Damage System ready: install ADS and the service points plus pre-shift inspection points appear where they belong on the machine. The spindle picking units are included.
- Use the Southland Super 20 LS boll buggy to move seed cotton from the picker over to the module builder.
- Its swing, offset hitch lets you run beside the picker.
- You also get a hydraulic packer, Big Lip dump door with rubber curtains, and quad unload chains.
- Boll-Vac.
- The Crustbuster 114″ is a pull-type module builder driven by the PTO.
- Drop seed cotton in from above, then let the bridge and tamper pack it during a full cycle.
- Once it reaches 100%, it forms a tarped Bailey Farms cotton module. Open the hydraulic rear gate and drive out to drop the module.
- There is a waving flag up top.
- The Lizard LM-6 module truck comes with a patina cab.
- Its slide-and-tilt bed has a chain floor, so modules load and unload on their own.
- The custom tarped cotton module has the Bailey Farms logo. The module builder makes it, the module truck hauls it, and it is ready for the gin.
Optional: Advanced Damage System (FS25_AdvancedDamageSystem) gives the 9970 full service and inspection support.
John Deere 9970 Cotton Picker
- 250 hp
- 4-row basket picker
- Hydrostatic drive
- Front duals
- Rear-wheel steer
- Spindle water tank: 275 gal (1,040 l)
Southland Super 20 LS Boll Buggy
- Lift & Shift boll buggy
- Swing, offset hitch
- Hydraulic packer
- Quad unload chains
Crustbuster 114″ Module Builder
- 130 hp needed
- Pull-type, PTO-driven
Lizard LM-6 Module Truck
- 350 hp
- 10-speed manual
- Hauls one Bailey Farms square module, 2.06 x 2.40 x 9.60 m
- Hauls up to four round modules
Bailey Farms Cotton Module
- Custom tarped cotton module
- Bailey Farms logo





